Ask Experts Questions for FREE Help !
Ask
    lee79lee's Avatar
    lee79lee Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Apr 2, 2007, 02:59 AM
    No water pressure
    I h ave a combi boiler and have just had some taps changed so need to turn of the boiler and the mains water. Once done turned all back on , made the pressure on the boiler back to 2 and a half bar but now the water pressure coming out of all hot and cold taps is very low.. how can this be solved?
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
    		  
    #2

    Apr 2, 2007, 06:09 AM
    Look for debris. Might have knocked some dirt or calcium loose during the valve change. Make sure all valves are full open.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Surging water pressure & leaking water heater relief valve [ 19 Answers ]

Just recently the pressure of our water in the house surges when we turn a faucet on, and the city water company verified that our pressure in the house when we open a faucet is higher than the pressure in the lines in the street, and after the water runs is at a normal pressure (meaning their...

No water to both sinks / very low cold water pressure to bath and washer [ 1 Answers ]

My kitchen and bathroom sink have no water, period. Hot water seems to be pretty good to the bath and washer but cold water to those 2 locations are very weak. The outside faucet is very weak at best. I have had this problem for quite some time so it's not the fact that they are frozen. I just...

Low water pressure oil hot water heating system [ 1 Answers ]

How does one go about increasing water pressure in a baseboard heating system?

House water pressure from well losing pressure [ 2 Answers ]

I have a well at my home that provides the primary water . I have replaced the well pump with a new one, the pressure tank was bad replaced it, pressure switch was bad replaced it. Now I cannot maintain pressure through out my house. The initial pressure is good for about 10 seconds then it slowly...

Low water pressure in an area known for high pressure [ 3 Answers ]

Greetings, My wife and I are in the process of updating 1957 side by side split level. The previous owner (OK, my Mom as I bought the house I grew up in from her) said that when they moved in they had to install a pressure reducer into the line. I have searched high and low but, I can't see...

View more questions Search