Ask Experts Questions for FREE Help !
Ask
    Bill2257's Avatar
    Bill2257 Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Jan 30, 2014, 01:16 PM
    Why bell end pvc elbows
    Not sure why bell end elbows would benefit in lieu of standard PVC 90
    smoothy's Avatar
    smoothy Posts: 25,490, Reputation: 2853
    Uber Member
    		  
    #2

    Jan 30, 2014, 01:31 PM
    In exactly what application?
    Bill2257's Avatar
    Bill2257 Posts: 2, Reputation: 1
    New Member
    		  
    #3

    Jan 30, 2014, 01:43 PM
    Using as conduit for wire
    ma0641's Avatar
    ma0641 Posts: 15,675, Reputation: 1012
    Uber Member
    		  
    #4

    Jan 30, 2014, 06:43 PM
    L conduit bend? Removable cap? If so, just a lot easier to pull long wire runs.
    stanfortyman's Avatar
    stanfortyman Posts: 5,598, Reputation: 279
    Electrical & Lighting Expert
    		  
    #5

    Jan 31, 2014, 05:20 AM
    Not sure why bell end elbows would benefit in lieu of standard PVC 90
    Because 99.9% of the time you need at least one coupling on a 90, so why not.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Pvc water pipe will not stay in elbows, outside wall of home [ 3 Answers ]

Outside wall has water pipe that evidently has to do with the tub faucet in bathroom. Copper pipe is connected with a copper snap on fitting recommended By the plumbing supply house, it is holding great, but the pvc elbow on one end blows the pvc pipe back out and or on the other end has coupling...

PVC toilet flange to cast iron with bell end gone [ 1 Answers ]

I have to connect a PVC toilet flange to a 3" cast iron pipe cut off below a slab (about 5 inches below top of slab. The pipe is exposed OK for a short distance, but not all the way to the next joint, but the cast iron bell was ruined in process of breaking the slab out and had to be cut off. ...

PVC pipe into cast Iron bell leaking [ 15 Answers ]

I've been using the advice on this site to replace a cracked length of cast iron and a cast iron Y junction with PVC, and up until this point, it's been going great. It's all back together now, but where the PVC goes into the cast iron bell, is leaking. I don't want to replace this because it...

Is there a tool for placing oakum?/pvc in iron bell coupling [ 7 Answers ]

Repairing someone's older repair. Water closet connects by 3"pvc into 4" iron sewer pipe. While trying to put the oakum in place most tools pass through the oakum without tamping it into place.

Pvc to cast iron bell [ 1 Answers ]

Hello all, I'm working on a bathroom replacing a tub. I've removed the tub and old drain connections, but now I'm down to the old cast iron trap with a bell on the end. I need to connect new 1 1/2" pvc for the new drain. How do you join the new pvc to the old iron bell? It looks like the trap...

View more questions Search