Ask Experts Questions for FREE Help !
Ask
    Servicedept's Avatar
    Servicedept Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jan 10, 2014, 11:23 AM
    Carrier furnace not heating,no gas smell replaced igniter same problem.
    Carrier furnace not heating,no gas smell replaced igniter same problem. Furnace is 10 yrs old
    ma0641's Avatar
    ma0641 Posts: 15,675, Reputation: 1012
    Uber Member
    		  
    #2

    Jan 10, 2014, 09:17 PM
    No blinking code? Power to the unit? 120 and 24 volts? Have an inducer fan? Does it run? What happens when it runs? You question, as posed, leaves a lot of unanswered questions.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

I have a goodman GDT090-4A gas furnace. The igniter will ignite the gas and the gas w [ 2 Answers ]

The igniter will ignite the gas, and the gas will run for a second or a few seconds and will then cut off. It will continue to cycle like this until it finally will stay on but at times will take forever.

I am getting 6 volts to surface furnace igniter (Carrier) no glowing [ 1 Answers ]

Blower inducer works, switches work. 115 volts goes to controller board. When I measure igniter feed lines they show 3 volts and once blower stars it max up at 6 volts. Is this a board problem? Do I need to read 24v or 115v? My igniter is 41-404. If I buy it can I just transfer the wires from old...

Carrier furnace igniter doesn't glow [ 3 Answers ]

I have a Carrier furnace 58PAV070-12 about 15 yrs old. When I turn on the heat, everything seems to try to light the furnace but the ignition coil does NOT glow red. The system tries 3 times and then locks out and then it blinks code 34. Is there some type of reset I am missing? I have unplugged it...

Carrier 58ssb gas furnace problem [ 2 Answers ]

My furnace will not keep running. After approx 10 minutes of normal burning, the burners flame out and then re-ignite over and over again (about 1 second on/ 1 second off) and the gas valve can be heard clicking on and off. If the furnace is allowed to cool and turned back on the process repeats...

Carrier hsp gas valve/igniter control [ 2 Answers ]

Please help!! I have a carrier gas pack with a hsp valve/ignitor and after going through the ignition procedure I get nothing. I have replaced the inducer board and the inducer fan does work, however that is the only thing that appears to work. BEFORE spending another 150 bucks on the hsp...

View more questions Search