Ask Experts Questions for FREE Help !
Ask
    kattz's Avatar
    kattz Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jan 7, 2014, 09:47 PM
    Coleman furnace DGAT070BDC
    I have been having problems for 2 winters now and its getting worse. My igniter starts then the flame will start then you will hear clicks coming from the gas valve. While the clicks are happening the flame will attempt to go out. Once the flame goes out the process will repeat several times. If the furnace is not successful then only the motor below the impellor will run for hours and my house will drop in temperature.
    I will turn the furnace off at the switch then back on and the furnace will work fine for many hours to several days then the problem will start again. I have cleaned eveything on the burner and replaced the sensor, module-ign (twice)
    I am short on funds and cannot get a new furnace and I have read about the heat exchange and that part alone is $950.00 could it be something simple or something I missed
    scottm989's Avatar
    scottm989 Posts: 1, Reputation: 1
    New Member
    		  
    #2

    May 7, 2014, 06:58 PM
    Have you found anything out I'm going through the same thing now
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Coleman furnace heat setting for coleman evcon furnaca modeld g a 207 5800 [ 0 Answers ]

Where is the heat anticipator setting for a coleman evcon furnace model dga2075800

Coleman Furnace [ 8 Answers ]

I Have a problem on a Coleman furnace, model # DGAA070BDTA. The problem is when the furnace kicks on, it lights the hot surface ignitor and lights the burner, but as soon as the fan comes on the burner shuts down and cycles about 5 times then shuts down. I have changed the board 2 times, replaced...

Coleman furnace [ 4 Answers ]

I have a coleman 7900b furnace that will run on continuous but the blower will not kick on on automatic. It works fine on the air conditioner setting but will not on the heater setting. Any suggestions?

Evcon furnace dgat070bdc won't ignite [ 4 Answers ]

I have an evcon furnace model # dgat070bdc and it will not ignite. My gas is full an the blower kicks in when heat is called for but I get no heat. I have replaced the hot surface ignitor an the ignition control. What is the problem?

Evcon DGAT070BDC want ignite [ 1 Answers ]

I have a Coleman/Evcon sealed combustion downflow gas furnace forced draft with direct ignition (hot surface); I use propane gas. The glow rod works and the pilot lights, but the ignition module clicks several times trying to light the furnace flame and then shuts down. It will try again with the...

View more questions Search