Ask Experts Questions for FREE Help !
Ask
    Devinet's Avatar
    Devinet Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jan 2, 2014, 05:16 AM
    Is the thermo couple in a green brier furnace universal
    I have a greenbrier furnace pilot lights burners do not
    parttime's Avatar
    parttime Posts: 1,440, Reputation: 113
    Ultra Member
    		  
    #2

    Jan 2, 2014, 07:05 AM
    Hi Devinet and welcome, If you post more information you'll have a better chance of getting a good answer, post make and model number will help. Good luck
    ballengerb1's Avatar
    ballengerb1 Posts: 27,378, Reputation: 2280
    Home Repair & Remodeling Expert
    		  
    #3

    Jan 2, 2014, 02:04 PM
    If you have a pilot light then you will have a thermocouple.
    massplumber2008's Avatar
    massplumber2008 Posts: 12,832, Reputation: 1212
    Senior Plumbing Expert
    		  
    #4

    Jan 3, 2014, 04:55 PM
    Most thermocouples are universal in nature, but if you have a pilot lit, then the thermocouple will not be the part that needs to be replaced...;)

    Mark
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Thermo Zone Furnace Replacement Parts [ 0 Answers ]

I have a GUO80M16B-S furnace and water is leaking from the 2in pvc pipe coming from the combustion motor from the exhaust. Where do I find a place to order a new one? The small hose from the combustion to the secondary heat exchange is the problem. Jim

I just replaced my thermo couple in my gas heater, I notice it is glowing red orange [ 0 Answers ]

Due to the flame hitting it. Is this OK for the couple. Is it supposed to be continuously glowing that hot?

Thermo goes below desired temp and will not initiate cycle. Thermo replaced HELP! [ 0 Answers ]

House temp goes below thermostat setting and furnace will not cycle unless I shut the system off and restart it again. This will give me two cycles and I have to start it all over again. I replaced the thermostat last week and it worked and cycled fine until today... What am I looking at?

Thermo couple [ 11 Answers ]

I had a thermo couple replaced in my furnace yesterday and I was charged 132.45. Is this a bit much?

Thermo couple didn't work [ 1 Answers ]

I have replaced thermocouple and cleaned the best I could The piot stays lit for a while but now it won't fire up at all? And then the pilot goes out Major draft inside of furnace also Is thst normal?

View more questions Search