Ask Experts Questions for FREE Help !
Ask
    mikehuard's Avatar
    mikehuard Posts: 2, Reputation: 1
    New Member
     
    #1

    Dec 30, 2013, 05:33 PM
    Rheem Classic 90 Plus intermittent cycle
    I have a Rheem Classic 90 gas furnace. Lately I have noticed that when heat is required, the furnace turns on normally but shut down after 10 minutes prior to reaching the required temperature. Within a minute the cycle starts all over again and shuts down after 10 minutes.

    I have noticed that when operating normally the 3 led lights are on (yellow, green and green). Then the yellow led turns off and the next led (green) flashes in sequences of 3 times, pause, 3 times pause...

    What do you think is wrong and can you tell me if I can fix it?
    Grady White's Avatar
    Grady White Posts: 1,417, Reputation: 59
    Ultra Member
     
    #2

    Dec 31, 2013, 06:54 PM
    Somewhere on the furnace, usually inside the blower compartment door or on the board itself is a key to the blink code. If you can find it, please tell us the meaning of a 3 code.
    mikehuard's Avatar
    mikehuard Posts: 2, Reputation: 1
    New Member
     
    #3

    Jan 1, 2014, 05:22 PM
    Hi Mr. White,

    It says 3 blips equals the limit switch is open.
    Grady White's Avatar
    Grady White Posts: 1,417, Reputation: 59
    Ultra Member
     
    #4

    Jan 1, 2014, 06:06 PM
    It could be a faulty limit switch but not likely. The most probable causes are: dirty or highly restrictive air filter, closed or blocked vents (either supply or return), dirty blower wheel, dirty A/C coil (if you have A/C connected to the furnace). There are some common problems listed, more or less, in order of easy to cure.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Rheem classic 90 [ 1 Answers ]

I have a Rheem "classic 90" furnace. The furnace has recently stopped working. Its as if it has no power. The fans don't come on and the igniter does not attempt to light the furnace. The breaker is not tripped. I have pulled the top and bottom panels off and there does not appear to be...

Rheem Classic 90 Plus [ 0 Answers ]

I have a Rheem Classic 90 plus furnace that has been working great. Last night we received a lot of snow (here in Northeast) and this morning the furnace was not heating. I could hear some start-up sounds, however when it would be time for the blower to start, the furnace would just shut off. I...

Rheem Classic 90 [ 5 Answers ]

I have a Rheem Classic 90 that leaks water on the floor whenever the central ac is running. I also have a Herrmidifier attachment as part of my system. Any ideas?

Rheem Classic 90 plus [ 0 Answers ]

Blower does not come on

Rheem 90 Classic [ 5 Answers ]

For the last month or so my two year old Rheem 90 Classic model #RCGA-36A2GG21XI condensing furnace keeps cycling on for a minute, the flame lights up, the fan comes on and then it turns off. A minute later the same thing happens for about 5 times. Then all of a sudden it works fine. A couple of...


View more questions Search