Ask Experts Questions for FREE Help !
Ask
    lmguerrero333's Avatar
    lmguerrero333 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Nov 25, 2013, 09:15 AM
    How to relight the pilot light after running out of propane
    I let my propane tank run out.. They just refilled it for me, but I can't figure out how to get the pilot light lit. can you help?
    smoothy's Avatar
    smoothy Posts: 25,490, Reputation: 2853
    Uber Member
    		  
    #2

    Nov 25, 2013, 09:52 AM
    Procedures may vary from manufacturer to manufacturer, but you have to put it to a light postiion and hold it how as its lit until the termocouple gets hot enough to release... then you adjust it to the correct temprature.

    If as you say happened you ran out of propane the possibility of air in the lines might mean this takes a lot longer than usual to relight.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

After running out of propane how do we light the pilot [ 4 Answers ]

We ran out of propane last night, got more today, and now we can't get the pilot to light... please help!

How do I relight the pilot light for SFB-50321A [ 1 Answers ]

This is an old Montgomery Ward direct vent wall furnace

How do I relight the pilot light for ANS Z21.44? [ 0 Answers ]

I have an old Montgomery Ward Direct Vent Furnace. How do I relight the pilot light? The only numbers I see on the furnace are ANS Z21.44

Cannot relight gas water heater pilot light [ 2 Answers ]

After I light it, my gas water heater pilot light always goes out when I release the pilot light knob. This occurs regardless of how long I have been depressing the knob (usually several minutes) to keep the pilot light going after I have ignited it.

View more questions Search