 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Intertherm M3RL furnace
I am replacing the Fasco Inducer assembly, on my M3RL 8=90+ furnace with 80K BTU, I reside at roughly 5000 ft, is the orifice needed on the Inducer, the old one did not have one, but HVAC repair and installation mgr. told me to verify
|
||||
Check out some similar questions!
Furnace kicks on and off when suppose to but when blower shuts down the heating element doesn't have to flip switch to shut off element
Furnace will run for 30 seconds. It shuts down and the yellow light will flash 6 times and the does the same thing over and over. Red light stays steady. Thanks for the help.
I have an Intertherm furnace, e2eb-017hb. It comes on briefly, blows warm air, then shuts off, and a clicking sound comes from the coil contacts area. I have tested the t-stat, and also replaced a coil contact, thinking that was the problem. I would appreciate any help on what to do next.
I need some diagnostic help. We have a full propane tank. A new burner plate (last year) and the blower works. We light the pilot but the knob should pop up after one minute thus lighting the furnace. It won't pop up. What part should we replace? The furnace is a 17 year old Intertherm MGH...
Hi, I just installed an intertherm m3rl 90+ downflow furnace today and what happens is the inducer fan runs and is venting proplerly, but when the flame lights and blower fan is signaled, the blower is blowing out the flame. How can this be possible unless there is some sort of leak in heat...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
