Ask Experts Questions for FREE Help !
Ask
    steven Harris's Avatar
    steven Harris Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Nov 7, 2013, 12:04 PM
    Roll out switch
    Won't light it leeks 5 times telling me it's a roll out switch I reset all three switches and it still tells me roll out switch
    Grady White's Avatar
    Grady White Posts: 1,417, Reputation: 59
    Ultra Member
    		  
    #2

    Nov 7, 2013, 08:51 PM
    You need to disconnect the a wire from each switch & test for continuity on each switch. If you find one without continuity, you've found your problem.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Goodman furnace- roll out switch [ 0 Answers ]

Roll out switch needed resetting. My service man says new furnace required. Is it possible that just a new switch could be needed?

Flame roll out switch [ 2 Answers ]

I have a carrier RTU. The heat side is not working. I am getting 7 flashes on the LED which indicates a flame roll out fault. What causes that, and what should I look to replace? Thanks

Furnace roll out switch [ 1 Answers ]

Can't seem to discover why the roll out switch above the top burner trips after about an hour of heater operation. Unitary Products horizontal propane furnace. Filters are clean, vent is clear. Cabinet near burners not excessively warm. The controller blinks 5 times until the switch is reset. ...

Roll out switch [ 1 Answers ]

What can cause a roll out switch to open on a warm air gas furnace

Roll out switch trouble [ 1 Answers ]

What can cause a roll out, the switch keeps tripping? The roll out can be seen but the exhaust blower is working. The heat exchanger is not cracked, I had it checked by the local gas company.

View more questions Search