 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Carrier furnace problems
I have just replaced one of the original two 7 day programmable thermostats that came with the Carrier Weather Maker II, 2 zone controller. The new thermostat is a Honeywell TH83200U1008 Vision Pro 8000. Will the new thermostat work with the original 2 zone controller? What is the interface problem? Heat pump will not activate when both thermostats are activated. I have had the heat pump checked out and is in good condition and charged.
|
||||
Check out some similar questions!
In the middle of the summer, with the thermostat in the OFF position, the blower motor in my carrier gas furnace started? What is wrong?
I have two furnances. One heats basement and first floor, and the other heats the third floor. The one for the main floor and basement makes a thumping or banging sound when the burners are on when it is colder than -15 degree Celsius outside.
I have a Carrier WeatherMaker Infinity Furnace - Ultra Efficient Gas Furnace. A while back we had some power surges which fried the circuit board and blower motor. We had both replaced. My problem started happening right after the fix. The furnace sounds like it's about to start up, then there...
I have a carrier furnace (17 years old) that quit recently. After wiggling a few wires, tapping here and there, I could get it to start up and operate for several days before it quit again. (it has electronic ignition) I can get it to work, but now it works only for one or two cycles (it's getting...
I have a carrier furnace (17 years old) that quit recently. After wiggling a few wires, tapping here and there, I could get it to start up and operate for several days before it quit again. (it has electronic ignition). I can get it to work, but now it works only for one or two cycles (it's getting...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
