 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Hot water heater cut off valve issues
Problem: changed the cut off valve (cold Side) twice on my HW heater. Ball and gate valve. Water still comes out of my faucets strong. Added a cutoff to the hot water side. Turned off one then the other then both. Let water run for 15 minutes, still strong pressure. Have never seen anything like this. Any ideals?
Lester |
||||
Check out some similar questions!
I had a leaking (plastic) drain valve on my GE hot water heater. It was leaking from the inside of the valve. The small rubber washer was crimped. I installed a new brass drain valve that I purchased from home depot using teflon tape. The valve now leaks from the threads of the tank/valve. I...
I have Bradford White hot water heater model no. MI403S6EN12 40 gallon. About week ago pilot light started going out. I can light it and get hot water, but then it goes out and when I need hot water again I have to light it again. Also water is not getting as hot as it used to-just getting warm....
Too hard to turn by hand
The internal breaker on my hot water heater keeps tripping (the red button under the panel). It doesn't pop the main circuit breaker at the panel though. This will happen every few days. I have noticed recently that when it pops there is a discharge of water from the hot water heater, although I...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
