Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
I have a VFD input 230V 28.5A... out put 230V 10A 3phase, what breaker & wire gauge?
[ 4 Answers ]
I inherited a 1972 Unisaw 3hp 3Phase motor. I have a 30 amp breaker going to my detached garage with a sub panel of 4 15amp breakers. The VFD to run the saw has an input of 230V single phase 28.5amps (I am not sure if this is the correct amount of amps, seems kind of high) and an output of 230V...
Inverter and deep cycle battery sizing calculation
[ 1 Answers ]
I have a combine load of 1400watts, I want to determine the inverter and deep cycle battery required to carry my load for the period of 10hrs a day.
Which Lead Acide battery is good for my UPS (Inverter) of 600 Watts
[ 2 Answers ]
I have a UPS(Inverter) of 600 Watt from which I am running 4 fans (60 Watt each) and 10 energy saver bulbs (13Watt each). 2 Lead Acid batteries (used in cars) of 12volts 60Amp and 65Amp each are connected in parallel. After 3 months the UPS kept on charging batteries and 1 of the batteries (65Amp)...
DC deep cycle battery, AC wattage on inverter etc.
[ 17 Answers ]
Hello again. Long time, no speak. I have a buddy that needs to put a battery bank into an old house boat he is fixing up. And I've had a heck of a time finding a calculation that'll allow a person to figure out AC wattage, that'll drain DC deep cycle batteries, with X amp hours. I've found online...
Residential Service Cable Type
[ 11 Answers ]
Once again, a res. Question by a comm. Electrician. I have a new project relocating a meter service. The new meter will be about 25 feet from the 200A panelbox location instead of back to back. I'll wire in a 200A 2 pole breaker at the meter location as per 10 foot tap rule, and run new cable to... View more questions Search
|