 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Rheem 80 - Main Burner Lights, No Fan
I have an old Rheem 80. My problem is the pilot lights, main burner lights, but circulating fan does not start. After a couple minutes with no main fan, burner goes out. If I put the fan in "ON" mode instead of "Auto" and then turn on furnace, pilot lights, main burner burns and heater works. However, move the switch back to "Auto" and fan turns off followed shortly thereafter by main burner.
Any ideas? |
||||
Check out some similar questions!
Of course, just as a cold snap is about to hit, our furnace quits working. Having fixed it successfully the last couple of times it quit - once due to the intermittent pilot ignition control module packing it in and once when a small spring had broken which was supposed to push on a micro-switch...
Of course, just as a cold snap is about to hit, our furnace quits working. Having fixed it successfully the last couple of times it quit - once due to the intermittent pilot ignition control module packing it in and once when a small spring had broken which was supposed to push on a micro-switch...
My Rheem Criterion II Heater does not ignite (no fire), even though the whole fan system keeps working. What's wrong? It happened two years ago. A contractor replaced an ignitor. Then it backed to work. Now, it happens again. Is it the same problem? Can I replace the ignitor myself? Where can I...
Ignitor Works, Furnace Cycles, Green LEDS on Board... No GAS
Day & Night gas (NG) furnace Carrier 800-19A on stamped ID plate Forced air We just moved in. The furnace has worked just fine several times. We keep the thermostat on the lowest setting, manually cranking it up for those few times that we need heat here in southern California. This...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
