 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Air Lock
I recently replaced a washer in my bathroom HOT TAP. I turned the water off at the shut off tap which is fitted on the hot supply to Bath. Now I have a problem with my hot taps Gurgling and spitting. I tried to bleed with a hose from the Cold tap no good, I tried leaving it running to see would it clear but it did not. The Bathroom is not as bad as the kitchen it seems OK for a while but then spits, There are only 2 Taps from my Hot Tank, Bath and Kitchen.
|
||||
Check out some similar questions!
Can some one help me, please I don't know what did my kids do my sony laptop, now I can't turn it on. When I turn on the laptop, only power, battery and hard drive lights are on but the screen is not on at all. All caps lock, Num lock and Screen lock lights are on all the time, the laptop doesn't...
Evening After filling my hot water cylinder, water only flowing from one tap out of three, any Suggestions D
Please help me to eradicate a very noisy cold water tap in my bathroom. When I turn the tap on there is a very loud juddering noise I suppose it could be air in the pipes but it persists.
I was just wondering how I can rememdy hammer lock or airlock? I think that is what it is. I just bought this house that has been sitting for 3 months unoccuppied. I connected my washer and when the washer starts to cycle by pulling water to the unit, I hear this bang evertime it purges water. ...
I am pumping water half a mile through 22mm pipework at mains pressure over a hill 20ft high and it then drops 60ft where the water comes out in at varying pressures and occasionally stops for a few seconds. Could this be caused by air trapped in the pipe at the top of the hill? The water runs...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
