Ask Experts Questions for FREE Help !
Ask
    llttpot's Avatar
    llttpot Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Sep 21, 2013, 04:51 PM
    Angle stop one piece
    How do you remove them??
    ma0641's Avatar
    ma0641 Posts: 15,675, Reputation: 1012
    Uber Member
    		  
    #2

    Sep 21, 2013, 04:55 PM
    Soldered on? Why remove?
    massplumber2008's Avatar
    massplumber2008 Posts: 12,832, Reputation: 1212
    Senior Plumbing Expert
    		  
    #3

    Sep 21, 2013, 05:33 PM
    There are too many different types of toilet shutoffs to help with so little information.

    Post a picture and we can probably help here... ;)

    Mark
    llttpot's Avatar
    llttpot Posts: 2, Reputation: 1
    New Member
    		  
    #4

    Sep 22, 2013, 10:12 AM
    Accor, makes them, push on. Guess I turn them counter clockwise while pulling. Not sure, any insight?
    ma0641's Avatar
    ma0641 Posts: 15,675, Reputation: 1012
    Uber Member
    		  
    #5

    Sep 22, 2013, 11:11 AM
    You made a second post clarifying. Just add to this post and not another. You Tube shows them twisting off but by more than 1/4 turn. Picture showed twisting to left and pulling. Came off in about 4-5 turns.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Angle Stop [ 1 Answers ]

Have you heard of an angle stop with a plastic knob that you should pull for water shut off to the fixture? My Mother has these in her house and can't seem to pull them out for water shut off.

T-connector to angle stop [ 2 Answers ]

Is it possible to connect a T-connector to the ACCOR, one piece angle stop

Angle stop with PEX [ 8 Answers ]

I would like the easiest route from a standard angle stop to a copper pipe (then to PEX). This is for a toilet supply. I would like to use a standard angle stop and screw it to a copper pipe, and use Shark Bite or Watts quick-connect to connect it to the PEX. I want to avoid using another...

Angle stop valve [ 3 Answers ]

Do you have any idea on how to install a stop valve under a bathroom sink? Thanks R. Koehn

Angle stop [ 3 Answers ]

What is a standard 1/2" compression angle stop? I am installing a sink faucet supply line

View more questions Search