 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Crank shaft
The crank shaft on my briggs 18.5h seems out of alignment. As I replaced the oil seal I could tell the shaft was a fraction of an inch closer to one side of the mower. Starts well but after a half an hour of mowing, the oil seal begins to leak at the base. No terrible noise and oil is clean. What might be causing that crank shaft to not be perfectly positioned?
|
||||
Check out some similar questions!
I have a 93 honda accord it does crank up but it takes awhile to crank up once its crank I don't have a problem with it it rides normal if I stop and cut it off and crank it right back up it will start right up but if I wait for awhile and then try to crank it it wouldn't crank right up it will...
Can you tell me where I can find the crank shaft position sensor on a Ford 6.0 powerstroke
I try starting my lawnmower (Craftsman DLT 3000, 18.5 HP), the engine starts to crank and locks up. I remove the spark plug and engine keeps cranking. When I put the spark plug back in the engine begins to crank and locks up. I can manually turn back the pully cover on top the engine and the...
'03 Honda civic hybrid--100,000 miles. Good batterey voltage--does not spin the "starter", when key is turned--checked both the in and the out clutch switches and both work properly. This is new diagnostic problem for me -- having vast experience with all other forms of vehicles. Haven't...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
