Ask Experts Questions for FREE Help !
Ask
    jawilson11241's Avatar
    jawilson11241 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Aug 2, 2013, 11:02 AM
    High side pressure for ft5bd-060k air conditioner
    I need to know what the high and low side pressures should be on a FT5BD-060K 5 ton heat pump that holds 16 lbs of refrigerant (r22) when it is full .out side temp is about 95 degrees.
    smoothy's Avatar
    smoothy Posts: 25,490, Reputation: 2853
    Uber Member
    		  
    #2

    Aug 2, 2013, 11:38 AM
    Sound like homework... as you will refer to the charts for that... and do a superheat and sub cool to find out where you should be... and relative humidity is also a factor.

    http://www.hvacsalesandsupply.com/Li...20Charging.pdf

    http://www.youtube.com/watch?v=Z6mUZIiSdUw
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Dodge stratus air conditioning high side has low and low side has high pressure how [ 0 Answers ]

Our dodge stratus 2001 air was cooling and then not cooling then cooling again Took it to our mechanic he said he did not know how to repair. The compressor was good, but the high pressure line is now low pressure, and the low pressure has highest pressure, he said he did not know what was causing...

Out side air conditioner doesn't switch on? [ 2 Answers ]

My outside unite doesn't switch on but the inside one does, it had a problem of icing and they checked the inside board, but bringing it back was fault , what's the problem

The high pressure side and low pressure side of my ac unit are at 115 lbs, what do I [ 4 Answers ]

I have a Goodman ac unit at my house,the high pressure side and low pressure side are equal at 115 lbs. How do I solve this problem, or what do I do to fix this problem.

R22 LOW SIDE and high side same pressure 120psi [ 2 Answers ]

r22 LOW SIDE and high side same pressure 120psi. Condensing unit works for 15 seconds and then stops

Do you add 30 410a freon pressure like you do r22 and r12 for high side pressure in c [ 1 Answers ]

Do you have to add 30 to the ambeint air temp. like you do for r22 and r12 to R410a freon to get the proper high side pressure reading

View more questions Search