Ask Experts Questions for FREE Help !
Ask
    SJM21229's Avatar
    SJM21229 Posts: 6, Reputation: 1
    New Member
     
    #1

    Mar 25, 2007, 06:26 PM
    Exterior Parged Block Wall
    I had my exterior foundation block wall re-parged, first they applied a mesh wire then a layer of hand mixed water proof cement and then a hand mixed coat of parge consisting of concrete & sand. The problem is the entire foundation is spider web cracking from the bottom up. How can this be repaired? Or is there a crack sealer/paint to fill in the excessive cracking? It's only been four months since this job was done.
    ballengerb1's Avatar
    ballengerb1 Posts: 27,378, Reputation: 2280
    Home Repair & Remodeling Expert
     
    #2

    Mar 25, 2007, 08:41 PM
    We call this application stucco and I have not personally done one. However it sounds like they may have used too much water. In any case, you should have more than 4 months warranty from the installer. I would make him come back and assess the problem.
    SJM21229's Avatar
    SJM21229 Posts: 6, Reputation: 1
    New Member
     
    #3

    Mar 25, 2007, 09:17 PM
    Quote Originally Posted by SJM21229
    I had my exterior foundation block wall re-parged, first they applied a mesh wire then a layer of hand mixed water proof cement and then a hand mixed coat of parge consisting of concrete & sand. The problem is the entire foundation is spider web cracking from the bottom up. How can this be repaired? or is there a crack sealer/paint to fill in the excessive cracking? It's only been four months since this job was done.
    There is no warranty & no installer. We had a large new additions construction job and the contractor along with his subs walked off the job and left us with a mess. Not Even FUNNY! The parge job is a cracked up mess and the color is really blotchy. Our new garage floor is all cracked up too.
    ballengerb1's Avatar
    ballengerb1 Posts: 27,378, Reputation: 2280
    Home Repair & Remodeling Expert
     
    #4

    Mar 25, 2007, 09:20 PM
    Bad portland cement or at least a bad mix. The floor is probably going to be strong enough, all concrete cracks to some extent. If you are totally on your own I'd try a Stucco paint or sealer. It is thick enough the fill and bridge the cracks.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

I want to remove a glass block wall [ 5 Answers ]

we bought a condo that has a glass block wall, floor to ceiling, measuring 8.67' x 8.67'. Each block is an 8 " square, 3 " deep. There are a total of 169 blocks. What is the safest, cleanest method of removing it? See attached photo. Thanks Ron

Glass block shower wall [ 2 Answers ]

I had a free standing glass block shower wall installed using a block pattern that does not come with end cap blocks. Currently it has the very un-attractive PVC frame. What are my options for hiding this to enhance the beauty of the glass blocks? There does not seem to be any options with the...

Concrete Block Wall Construction [ 1 Answers ]

I am looking at putting in a cinder block wall (50' x 6'). It is in Calif. And in a no freeze area. What is needed for the footing? Depth, width, filler, and re-bar? I think that it needs to be 12" deep and 16" wide with 6" of crushed rock as the base, not sure on the re-bar requirement. How...

Mold on outside cinder block wall [ 2 Answers ]

I have black mold growing on my outside cinder block wall sourendering my back yard. I live in Las Vegas so the climate is dry but watering the lawns is causing the mold to grow since we have to water in the evenings so the water does evaporate so fast due to the hot climate. How do I remove this...

Supply and drain on exterior wall OK? (wisconsin winters... ) [ 2 Answers ]

Hey tom, thanks ahead of time for you're advice, :) What are your thoughts on placing supply and drains in an exterior wall. (knee wall in converted attic). I really don't have an alternative. The pipes being in the knee wall, I could always double up the wall and insulate the heck out of it. I...


View more questions Search