 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Off-centered dryer to floor vent installation in a mobile home
I am replacing my Whirlpool Duet dryer's vent hose with a rigid aluminum 4" duct. I live in a mobile home so the dryer is vented through the floor and out through the underpenning at the back of the house. The hole through the floor is off-center from the vent on the back of the dryer. Can I use two 90-degree elbows set perpendicular to each other to connect to my duct under the house? If not, what method/parts should I use? Once I connect to the duct through the hole in the floor, I will need to use at least one more 90-degree elbow. Is this okay? I will be using about 10' of duct.
|
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
I'm installing a newer CMF furnace that came with a 4" base. Do I need that base?
I need to install a 4" dryer vent thru my floor of my laundry room.The reason for going thru thr floor is because the room is in the middle of the house and there's no exterior wall in the room. It will go into the crawl space and out through the closes wall.My question is after I cut my 4 1/8"...
My kitchen sink was draining slowly and by process of elimination I concluded it must be the aav.as I removed the old one the drain started working properly.I replaced it with a new one and it worked normal for a day and then the sink started backing up again and draining really slow.it looks as if...
Need to remove mobile home bathroom floor for repair. Soft spots,tub cracked.Would like step by step instructions if possible. Need to get started, not sure where to begin.
My mom's thermostatic went out when my cousin did something to it... She had some guy to put another in but something went wrong and it burned some internals when he put the power on it. When I got to look at it there were no labeled wires and there was a yellow, green, black, brown, white, blue,...
View more questions Search
|
