Ask Experts Questions for FREE Help !
Ask
    DeutschWolf's Avatar
    DeutschWolf Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jul 6, 2013, 04:02 PM
    Small switch with high amps?
    I'm only starting to learn about electronics, so forgive my confusion please.

    I would like to install a switch on my desk to turn my PC power on or off. It is a novelty safety-type switch meant for 12V 2A applications. The PSU of the PC is around 500W with 20Amps, so obviously this little RC-style safety switch will melt or something if I simply cut the power wire (220V) and solder the switch in.

    So my question... what wire gauge is recommended for this type of electrical load?
    How can I still use this switch that I have? Do I need to install a relay?


    Thank you
    donf's Avatar
    donf Posts: 5,679, Reputation: 582
    Printers & Electronics Expert
    		  
    #2

    Jul 7, 2013, 06:46 AM
    Most power supply's are "Switchable". They are made to cut off if the amperage or voltage are to high or to low.

    What you are proposing to do is not necessary. The front of the computer should have an "On/Off" switch.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Can I use a 60 amps breaker (feeder) with the total load of 90 amps for a sub panels? [ 4 Answers ]

Circuit break amps too high for kitchen range? [ 3 Answers ]

Have a four-year-old Jenn-air range that started acting like it had a gremlin in it about a year-and-a-half ago. For over 2.5 years it worked fine. Then, it went through a couple of months where there would be an intermittent failure and it would say there was a probe installed (there wasn't). We...

Amps are too high on fuse [ 3 Answers ]

Coleman Furnace Model # G9t08012upb13c 3 Amp fuse keeps blowing. We tested board and the amperage cosistantly above 3 Amp rating. Why is this happening and how can we fix it?

Water pump motor drawing high amps at start up [ 3 Answers ]

I have a 240 volt motor for our water pump that draws high amps for a long period when it turns on. I know that the motor will draw high amps at start up, but the high amps stays high for about 8 to 10 seconds. The pump and motor are in a pit with an air bladder. Is there anything I can do so...

Cost to upgrade from 100 amps to 200 amps and ground [ 4 Answers ]

StanFortyMan has made a lot of sense about my needs in a home with a 100 AMP Service.. I would like to upgrade to 200 amps.. with some ground sockets(or whatever this is called) and put in more sockets... The house is 1300 square feet... does anyone have a guestimate of costs?? Thanks, Annie

View more questions Search