Not your question?
  Ask your question
  View similar questions
   
  
 Add your answer here.Check out some similar questions!
Where do you put the seats&springs when putting back together a tub faucet?
 [ 0 Answers ]
 http://www.deltafaucet.com/customersupport/documentation/612-c.html?document= Three way mixing valve 
Considering lowering springs
 [ 5 Answers ]
 Would it be a bad idea to put lowering springs (pro-kit) on my Mazda3 sedan considering I drive around 420 miles a week? It would be for appearance purposes only. Should I be concerned about the accelerated wear and tear on other parts especially with the miles I will be putting on it. 
Compression springs and extension springs
 [ 2 Answers ]
 I am an artist trying to figure out which extension spring to buy to hold back three compression springs. I am using 3 compression springs with the following attributes: deflection a load = 1.1" load lbs =1.95 and rate lbs/in = 1.77 (these are the specs in the catalog) they are stacked in a... 
Physics: springs
 [ 1 Answers ]
 
A 0.50 kg block, starting at rest, slides down a 30.0° incline with kinetic friction coefficient 0.23 (the figure below). After sliding 83 cm down the incline, it slides across a frictionless horizontal surface and encounters a spring (k = 33 N/m). (a) What is the maximum compression of the... View more questions Search 
  |