How do you remove cover of Trane Thermostat

will garnett Posts: 1, Reputation: 1

New Member

Jun 24, 2013, 12:00 PM

How do you remove cover of Trane Thermostat

How do you remove the front cover of a Trane thermostat, pry off ,pulloff,push button ?

Grady White Posts: 1,417, Reputation: 59

Ultra Member

Jun 24, 2013, 06:12 PM

Most come loose by pulling the bottom off first.

Add your answer here.

Check out some similar questions!

How to wire a trane 900 series thermostat to a trane XL13i heat pump [ 1 Answers ]

How to wire a trane 900 series thermostat to a five wire XL13i heat pump system.

Trane XL20i heat pump requires Trane 900 series thermostat? [ 2 Answers ]

Hi, I was wondering if the Trane XL20i heat pump requires the use of Trane's 900 series thermostat or if a Honeywell VisionPro IAQ thermostat can be used.

How do I remove a Carrier Thermostat that has a Locking Cover? [ 1 Answers ]

I have a carrier thermostat (33CSSP2-FC) that needs to be replaced. I have the owners manual and it says it has a locking cover w/ Tamper proof screws but does not mention how to remove it anywhere. I couldn't even see the screws to attempt to remove it. How do I go about removing it from the wall?...

On Trane XE 60, how to remove front cover and start pilot light? [ 1 Answers ]

This is a Trane XE 60 unit, model TUP080B936A with a standing pilot. Our heat did no go on this morning. I turned the circuit breaker off. 1. How do I remove the front panel? 2. Will the location of the pilot light be obvious? 3. Should the pilot light still be on or would it have been...