 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Thermostat installation diagram wiring Honeywell RTH221
Went to install a Honeywell RTH221 on my Miller/Amana System-- System was working fine just wanted to upgrade to programmable. Terminals on old therm,
RC/RH (Jumpered),Y C W G. On 221, RC/RH Jumpered, Y,W,G,B. After reading previous posts I taped up the Blue, Turned On the Power, Nothing --No Display.Killed the power, Connected B to B--still nothing! Reinstalled the old therm. Call in for cool but the system won't engage. Any Ideas what I might have done? |
||||
Check out some similar questions!
I am going from an old mercury trane thermostat to a new honeywell Th8000. I have a gas furnace and an electric heat pump. It seems to work most of the time and them for some reason in the morning when the heat kicks on, it will be on for awhile and then goes into "wait" I believe it is in the...
I have a 4 zone recirulating hot water heat system run off Propane. One zone running the hot water unit. A few years ago I replaced all I replaced the three Thermostats with programmable ones. However after a couple years they don't work the way they should or trying to reprogram them sometimes...
I have a trane heat pump in my home. I am attempting to install a Honeywell TH3210D1004 in place of the current trane weathertron one that is currently installed. My question is where do the white and tan wires go. I have found homes for the rest of them. There are two slots left "aux" and "l"....
I just installed a Honeywell RTH221 Thermostat. The old one had a red, green, yellow, and black wires. I installed the black one to the yellow connection. Now the unit runs backwards... heat instead of cooling... cooling instead heating. How should I have connected the wires?
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
