 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
How to remove the window from a basement hopper frame
I need to remove the window from a basement hopper window (tilts down). The window has two tabs on either side of the window and the window tilts so that the left side is higher than the right side, but not enough for the tab to clear the frame and remove the window. The tabs don't seem to "depress" to allow window removal either. How do I remove the window to repair the outer pane in this two-paned window?
|
||||
|
||||
|
There are 2 mounting tabs. Lift the window a couple of inches and tilt it in, grab the sash at the frame, pull the right side down and slide the left side up. You should see the hole or latch where the sash pin fits. On the diagonal, the window has plenty of space to come out. Unless this is a very peculiar window, they all come out this way.
|
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
I purchase a new home and when I moved it was the beginning of winter, I immediately noticed the windows on the second floor were very drafty, when you place your hand near the joints of the window (where the glass meets the wooden frame) you clearly feel current of cold wind coming in. The...
How do you make a round top window frame? Where can someone go to get some instruction on doing it and the kind of wood to use?
I would like to install a chair rail in my office. The placement of the window in the room is exactly 36 inches from the floor. A chair rail should be placed 32 to 36 inches from the floor. Also, the window has no frame, only a sill and a decorative trim under the sill. Where do I place the...
Hi I discovered a section of rote on the lower corner of a window frame. The window is a small wooden slider type. The section is about 2 inches in height and is evident both inside and outside. Can I repair this section or do I need to replace the window?
What is the best way to install trim molding around a window frame on the drywall or sheetrock. Should I use finishing nails and should I also glue the trim too?
View more questions Search
|
