Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Replacing a Rheem 5 wire condenser fan motor with an Emerson 4 wire condenser Fan
[ 0 Answers ]
I have a Rheem a/c unit that the fan motor quit. I took all the information off the old motor and went to a local supply store and they cross-referenced the numbers and gave me and Emerson motor. All the specs are the same, 1/5 HP, 1075 RPM, 60 Hz, 1.3 Amp, single phase. When I got home, I took...
The compressor fan is not running but the condenser clicks when I turn on the A/C
[ 1 Answers ]
The inside system turns on and blows air but it is warm air. I checked some web sites and did some troubleshooting. The condenser fan does not come on but the contactor clicks when I turn the A/C to cool and Auto. What else should I do I checked the contactors and capacitor but they didn't look...
Heat pump outdoor fan runs not compressor voltage at compressor good. New compressor
[ 1 Answers ]
Have a new compressor. Just replaced fan runs compressor does not, have voltage at the compressor plug? What could stop from coming on high side and low side equal at 100psig.
Can my condenser fan run while my compressor runs
[ 1 Answers ]
My condensenser fan would start and stop I removed it from the pressure switch and wired it so it runs when the compressor runs is this OK??
AC condenser compressor and fan not working
[ 1 Answers ]
The inside blower motor works, just the outside unit will not turn on. Everything is fairly new. I replaced the capacitor, contactor, and the Hard Start Kit. Everything looked fine. Niether compressor nor fan will turn on by itself. I pushed on the single pole contactor and the unit jumps to life... View more questions Search
|