Ask Experts Questions for FREE Help !
Ask
    RJD3RD's Avatar
    RJD3RD Posts: 1, Reputation: 1
    New Member
    		  
    #1

    May 20, 2013, 02:32 PM
    Armsrtong Ultra III 80 no A/C
    My Armstrong Ultra III 80 works fine on heat but when I put the A/C on I get nothing. I turned the on/off switch and it will stop the heat from coming on but still no A/C blowing.
    ma0641's Avatar
    ma0641 Posts: 15,675, Reputation: 1012
    Uber Member
    		  
    #2

    May 20, 2013, 02:34 PM
    Bad contactor, wire at condenser chewed-broken, thermostat bad, compressor bad, low Freon.. Have to start looking somewhere!
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Armstrong ultra III 80 furnace problem - cold air [ 0 Answers ]

Hi, I have an Armstrong ultra III 80 gas furnace that is blowing cold air. If I reset the furnace, I get heat but after the initial reset, I get cold air as oppose to heat. I have replaced with a new filter, area is unobstructed. I checked online and someone with a similar problem has indicated...

Kenmore ultra wash III dishwasher - Rubber band [ 0 Answers ]

After funning through cycle, I discovered that a red rubber band has come loose and was around the bottom water sprayer. Does anyone know how this goes back on?

Ultra wash III model 6651765994 motor removal steps [ 0 Answers ]

Trying to remove motor. All associated parts inside have been removed,there is a small plastic disc on motor shaft inside that seems to be preventing motor removal, what else needs to be done to remove the motor, so I can check the bearings?

View more questions Search