 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
Check out some similar questions!
The line from the well has 3 wires where should the bare ground wire be attached? The line from the house has 3 wires where should the white ground wire be attached?
We lost water pressure in our house last night. We have a well pump 360 feet down. My 1st thought was the well pump has finally failed. I though a moment and remembered there is a pressure switch in the basement so decided to check that. The pressure read only 30. That seemed a little low. I...
Several years ago I purchased a Vanguard V-Twin, horizontal shaft engine and it's been in storage ever since. I did start and run it a couple of times a year. I am now going to put it into service. I had to install the wiring harness, but the book that came with it was one of those don't do this...
I am installing a new water pressure tank and am wiring up the pressure switch. It has 4 electric contact screws, the outside two are labeled L1 and L2. The middle two are M in a circle. The pump is wired 220. Which screw contact do I hook up to the service box and which to the pump, and do I...
Hi everyone, I am having problems with my well this week and right now have no water at all. I saw earlier in the week that the old pressure switch contacts were in very bad shape so I cleaned them but a day later it quit working. I bought a new switch this morning and put it in after about 10...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
