 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
I have a Kenmore HE3 Gas dryer, the dryer will ignite and run for several minutes but
My Kenmore HE3 will start and run, flame wiill ignite and run for several minutes but will not relight when dryers calls for heat. Glow plug turns on but gas valve will not open. I have continuity through gas valve coils, thermistor,Thermal fuse, highlimit thermostat and flame sensor
|
||||
|
||||
|
It sounds like the safety is turning it off due to a build-up of dirt lining the air ducts and blower. You will need to totally tear it down and clean it out well before going any further. Then look at these and use a meter: https://dl.dropboxusercontent.com/u/...%20Manuals.zip
You will need a good volt/ohm meter to test it. |
||||
Not your question?
Ask your question
View similar questions
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
How do I run a diagnostic test for kenmore elite he3 gas dryer?
[ 1 Answers ]
How do I run a diagnostic test for kenmore elite he3 gas dryer?
How do I run a diagnostic test for kenmore elite he3 gas dryer?
[ 0 Answers ]
I have had a Kenmore Elite he3 gas dryer for 6 years. It suddenly would not start. The "clean lint" lite keeps flashing. I vacumed all vents, took off the back vent, vacumed the dryer and the wall vent. I washed the screen and it still will not work. Is there a diagnostic test I can run? All...
Kenmore gas dryer HE3
[ 1 Answers ]
I keep getting an error message E1 - don't know what it means, but the dryer shuts down.
Kenmore HE3 gas dryer
[ 1 Answers ]
I have a model 11092832100 that stop heating. I replaced the thermal fuse and the pilot won't say lit long enough to fire up the heater. Any ideas?
View more questions Search
|
