Ask Experts Questions for FREE Help !
Ask
    JSmith26's Avatar
    JSmith26 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    May 2, 2013, 05:27 PM
    How to find the model number for for briggs and stratton 5hp on a tiller
    How to find the model number for a BS 5hp engine on a tiller. The blower housing is gone. It is not on the valve cover
    crigby's Avatar
    crigby Posts: 4,343, Reputation: 107
    Outdoor Power Equipment Expert
    		  
    #2

    May 7, 2013, 07:59 PM
    Hi,
    Does the flywheel have a squared- of post for the starter to attach to or a round cup with raised notches on the inside. Posting pictures could also help.
    Peace,
    Clarke
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Older Craftsman Tiller w/5hp Briggs and Stratton [ 11 Answers ]

I recently acquired an old tiller that I have gotten to run. It will only run on full choke. It will only till for about a minute or so before going dead. It will idle for a long period, but it's kind of a rough idle. Do I need to adjust the carberator? I have already changed out the gas and...

5hp briggs and stratton tiller motor need model # or replacement motor [ 3 Answers ]

I have an earthquake tiller model 5020 with a 5hp briggs and stratton motor that I need to replace but I can not find the model of the motor. Does anyone know which motor replaces that motor or do you know the model number of the motor that was used on that tiller?

Need a wiring diagram for a 14.5hp Briggs and Stratton model number 287707-0224-01 [ 0 Answers ]

Need a wiring diagram for a 14.5hp Briggs and Stratton model number 287707-0224-01. Looked on the Briggs and Stratton site, was unable to find. Thanks in Advance

Can I replace a Briggs & Stratton engine model 31F707 (17hp) with a 31C707 (17.5hp)? [ 1 Answers ]

My B&S 31F707 17hp engine locked up and can't get it to turn, so looking to replace the engine with a B&S 31C707 17.5 hp since it is less than half the price of an exact replacement. Does anyone know if this will work? Or what I need to look for specifically to see if it will fit?

Briggs & Stratton 3.5hp Model 98902 [ 2 Answers ]

I have a Bolens Edger with a 3.5 Vertical Shaft Briggs which I purchased used with this problem: After priming the carb, the motor will start (it may take a couple of tries to keep it running) Once it keeps going, the engine seems to oscillate (revs up and dies down, revs up and dies down...

View more questions Search