Ask Experts Questions for FREE Help !
Ask
    Uncle Ray's Avatar
    Uncle Ray Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Apr 28, 2013, 09:17 AM
    What oil in18.5 HP Intek Single Cylinder
    What type oil do I use in my Intek 18.5 hp OHV and hiw much
    crigby's Avatar
    crigby Posts: 4,343, Reputation: 107
    Outdoor Power Equipment Expert
    		  
    #2

    Apr 28, 2013, 03:56 PM
    Hi,
    A good quality 30Wt of SH or higher grade. Amount depends on the presence of a filter or not; about 48 oz. without and about 54 oz. with filter. Always best to get it to the full mark patiently by slowly adding and repeatedly checking toward the end.
    Peace,
    Clarke
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

18.5 hp Briggs, OHV single cyl Intek Backfire [ 3 Answers ]

I recently acquired a 2004 model Murray rider with the afore mentioned engine.The problem is this, when idleing it runs snooth, advance the power and it backfires through the carb. I checked and changed the flywheel key( had the wrong key installed and was partially sheared), cleaned the carb,...

17hp intek briggs,uses oil no leaks noticed [ 5 Answers ]

I fill the crankcase to the full mark on my 17 hp Briggs motor, and for some reason it disappears after a couple of mowing. I can not see and leaks etc

18 hp briggs and stratton intek oil blow by dipstick [ 1 Answers ]

I have a Briggs & Stratton Intek 18 HP engine (31H777-0202-E) mounted on a Craftman Lawn Tractor that is about 7 years old. Recently I had notice oil covering the dipstick tube and inside of tractor hood in the area of the dipstick. While the motor was running I removed the dipstick and notice...

Briggs & Stratton 18.5 HP OHV Intek Plus - Single Cylinder [ 8 Answers ]

Help! I just replaced the short block on this motor and I cannot get it to run. I've adjuseted both intake and exhaust valves to 0.004 at 1/4 turn past TDC and no luck. It cranks over and kicks back on the compression stroke with smoke out the carb. So far it has not kicked over at all yet. What...

B&S 18.5HP Intek, oil/gas coming from fuel pump [ 5 Answers ]

Gas comes out of the screen on my fuel pump and the engine smokes like it's on FIRE when its under a heavy load. I replaced the fuel pump but this did not help. Someone suggested the crankcase vent might be stopped up, but I can't find a vent anywhere. The engine starts fine and idles without...

View more questions Search