Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Dynavent gas wall furnace lights and then goes out
[ 7 Answers ]
My Dynavent gas wall furnace glo-bar comes on and flame ignites and then goes out and then cycles back to the glow bar on again. Flame ignites and goes out after a few seconds. I replace the wiring harness and ignition control about two years ago. Could this be a problem with the flame sensing...
Trane gas furnace only one gas burner ignites temporarily then shuts off
[ 1 Answers ]
Have a Trane XL80 furnace. We switch the furnace on but after the initial ignition it turns off. And then repeats about a minute later, and then again. Only one and sometimes three of the burners are temporarily igniting. We have removed and cleaned the heat sensor and replaced the igniter...
I have a goodman GDT090-4A gas furnace. The igniter will ignite the gas and the gas w
[ 2 Answers ]
The igniter will ignite the gas, and the gas will run for a second or a few seconds and will then cut off. It will continue to cycle like this until it finally will stay on but at times will take forever.
Have a rheem criterion 2 gas furnace (1X2000), our gas was out for three days (Tucson
[ 0 Answers ]
Have a rheem criterion 2 gas furnace (1X2000), our gas was out for three days (Tucson Az ) Now it’s back on, and both furnaces start and stop about ever 4 to 10 minutes View more questions Search
|