Ask Experts Questions for FREE Help !
Ask
    chucklewis's Avatar
    chucklewis Posts: 1, Reputation: 1
    New Member
     
    #1

    Mar 3, 2013, 11:52 AM
    Goodman furn igniter works intermittingly
    I have a Goodman GMPN120-5 and the igniter works intermittingly. It times out after 3 times when the igniter doesn't glow. The igniter has been replaced at least once before we bought the house. The igniter that is currently on the furnace is wire nutted and I'm not sure if this could be my problem. Usually the furn works but lately our problem is getting more frequent. I'm open for suggestions...
    mygirlsdad77's Avatar
    mygirlsdad77 Posts: 5,713, Reputation: 339
    Plumbing Expert
     
    #2

    Mar 3, 2013, 12:50 PM
    May be more of a pressure switch not closing issue. What code is the diagnostic light on your control board flashing. Normally a hot surface igniter is either good or bad, very seldom will it work sometime and not others when correct power is being supplied to it. Chech for power to the igniter when it should be glowing and let me know what you find.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Goodman furnace no power to igniter [ 1 Answers ]

Myi have no power to the igniter on my goodman furnace

Goodman heater will not ignite with igniter [ 0 Answers ]

I have a goodman heater and it has been presenting the same problem for two years now. When turned on, the inductor fan (I believe it is called) will turn on, the ignitor will glow, and then the gas valve will click, and release gas, but it will not actually light. It tries this three times,...

Goodman and igniter or ignitor [ 3 Answers ]

Goodman model GDT070-3B Light blinks 3 times -- the codes indicate the info below. Pressure switch failure to close -- Venter pressure switch vent blockage. The small motor starts and then I can hear gas flow (can smell a small amount later) and then it shuts down. There is never a flame. ...

Goodman igniter not working [ 14 Answers ]

I have a Goodman GMP125-5 Rev B. The flue fan starts up and then I hear a click like the igniter should be glowing, but it doesn't. I replaced the igniter last year. I also pulled it and there are no cracks. This is the first time I have attempted to use the heater since last spring. Thanks, Al

Goodman furnace igniter stays on 20 sec with pilot light [ 1 Answers ]

Have a Goodman forced air unit in my garage, was used only now and then, a while ago it started this... turn furnace on and igniter comes on and lights pilot then stops for a second then comes back on for about 20-30 seconds... all this time pilot is light and strong... then igniter stops and...


View more questions Search