Ask Experts Questions for FREE Help !
Ask
    Jbolin1712's Avatar
    Jbolin1712 Posts: 1, Reputation: 1
    New Member
     
    #1

    Feb 13, 2013, 12:49 PM
    Delta 1400 bath faucet
    I replaced cartridge and cleaned what calcium deposits I could. Still have half the pressure I should have
    scott53715's Avatar
    scott53715 Posts: 165, Reputation: 10
    Junior Member
     
    #2

    Feb 14, 2013, 10:24 PM
    When you turned the water back on, some debris in your supply pipes could have made its way to the back of your cartridge reducing your pressure. Or, your shut-off valves are not fully open. You can try to flush out the valve by opening up the shut-off valves a little and allow water to flow, and then try rinsing out the cartridge and reassemble. Hope this helps.
    massplumber2008's Avatar
    massplumber2008 Posts: 12,832, Reputation: 1212
    Senior Plumbing Expert
     
    #3

    Feb 15, 2013, 06:51 AM
    If the pressure is OK at the tub spout then you may simply have a clogged shower head. In this case, remove the shower head and run the water without the head in place. Clear the shower head of any sediment/gunk and replace.

    If that fails to work, then follow Scott's advice above... ;)

    Mark

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

I have a Delta 1400 faucet in my shower that has been leaking. I took the cartridge [ 3 Answers ]

I have a Delta 1400 faucet in my shower that has been leaking. I took the cartridge out and replaced the springs & washers and it still leaked. Someone suggested springs needed to be pulled out... did not help. Tried new cartridge in and leaked worse. Put the old one back in and tried putting...

Delta monitor 1400 bath valve handle removal [ 1 Answers ]

Delta 1400 bath Valve handle will not come off. Set screw has been removed. Soaked in WD40, soaked in white Vinegar solution. Still will not come off. Handle is 2 pieces. Half of the handle unscrews and removes but main base of handle will not pop off Any help would be appreciated

Delta bath Faucet won't shut off clockwise [ 0 Answers ]

Hello, I have a Delta show unit that won't shut off anymore clockwise. It feels like its kind of bumping up against something, so I have to shut it off carefully in the center position which is a pain. Is this something easy to fix (cartridge)? I have attached a photo of the model. Thank...

Leaking single handle Delta faucet in a bath tub [ 2 Answers ]

I have a steady-dripping single handle Delta faucet in an upstairs bathtub. It has a pretty good leak. How do I get to the leak to fix it and what do I need to replace?

Delta bath faucet (cold) won't turn off [ 1 Answers ]

My delta bathroom faucet (the cold) won't turn off. Started as a small stream, now it is at full tilt. We have taken it apart and replaced the washer/seating and the cartridge. It is quite old (about 17 years)... there is a hot/cold and a hand held shower as part of the set.


View more questions Search