Ask Experts Questions for FREE Help !
Ask
    tidesny's Avatar
    tidesny Posts: 12, Reputation: 1
    New Member
     
    #1

    Feb 9, 2013, 02:40 PM
    Pressure Switch Goodman Furnace
    My furnace starts and stops after trying to ignite. I have changed the ignitor (it lights), the flame sensor(all burners ignite) the inducer works and then the furnace shuts down, I took out the filter to see if it was receiving enough draft and it was. Could this be the pressure switch and why?

    Thanks,
    mygirlsdad77's Avatar
    mygirlsdad77 Posts: 5,713, Reputation: 339
    Plumbing Expert
     
    #2

    Feb 9, 2013, 03:48 PM
    The unit lights, but after a few seconds it goes out? Sure sounds like a dirty flame sensor (not to be confused with the igniter), but you say you replaced that? No need to replace it, just need to clean it with steel wool or sandcloth. If that doesn't do the trick, check and clear all your condensate drain hoses and connecting ports. Let me know what you find. If it is a pressure switch issue, the diagnostic light on the control board should be giving you an error code.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Goodman furnace pressure switch failure [ 3 Answers ]

I have a Goodman GMH80 gas furnace and it quite at the end of last season, I found that the pressure switch was bad electrically and replaced it with a new one. (I actually took it the old one apart to see what happened to it, I cleaned and realigned contacts and switch now works). Today I hear the...

Where is the Pressure Switch on a Goodman furnace? [ 1 Answers ]

I am trying to locate the pressure switch on my furnace, any help would be appreciated.

What makes a venter pressure switch close on a Goodman furnace? [ 0 Answers ]

I just had a new condrnsate pump installed. Is it possible that it was not connected correctly?. As I said before, I've repaced the pressure switch and it worked the first time I started my furnace.

Goodman Furnace Pressure Switch [ 9 Answers ]

When my furnace tries to come on it blinks 3 times which tells me my pressure switch failed to close. I went and got another one and put on and it is still doing the same thing. When I jumper it out the furnace comes on and works normally. I checked the vent and it is free of debris. Is it...

Goodman Janitrol Furnace pressure switch fills with condesate [ 1 Answers ]

I have a Goodman Janitrol gas FHA furnace which has been shutting down due to the pressure control switch line fills with condensate. The furnace is vented to the outside and is about 15-20 yrs. Old. Any ideas as to what the problem may be and how to correct it?


View more questions Search