 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
My furnace trane xe80 has 4 flashing lights for the thermal protector on
I have replaced the thermal protector. Furnace ignites then shuts down after a couple of minutes and continues doing this. When ignites, slow steady flash. Then back to the 4 flashes when furnace shuts down again what is causing this to happen. When I put in the new protector furnace ran for 12 hrs heating it seemed as if it was running all day a lot
But now back to doing the same thing by shutting down |
||||
Check out some similar questions!
I have an xe80 gas furnace heater turns on but no heat and fan keeps running cold air. What's wrong with my furnace?
I have furnace trane xe80, could not start at all. I try fan did Not start also. I switch termostat to cool ,just to check out,does not start either,fan does not worked.
I have a XE80 furnace (installed sept.1995) the light blinks five times. The thermostat is off but a fan motor comes on that can be heard at the return vent.
One morning about a month ago, my furnace wouldn't start. The repairman came and replaced the "inducer draft motor and blower assembly". Not cheap! At that time I didn't know enough to record the blinking light code, but looking back I think it was blinking 3 times. Now, a month later, at 6 am...
I have furnace that calls for heat from thermostat, ignition coil(stick) lights up, sometimes I get gas ignition and sometimes not, then the gas shuts down. The blower motor continues to run. I cleaned the temperature sensing rod. The control board lights up with the message "Internal control...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
