Trane xr95 furnace

Wordchipper Posts: 1, Reputation: 1

New Member

Jan 17, 2013, 07:31 PM

Trane xr95 furnace

We just replaced a 16 year old Lennox gas forced-air furnace and AC with a Trane XR95 gas forced air unit. I have a Honeywell thermostat, digital. The furnace seems to cycle a lot in colder weather... the Lennox ran for 20 minutes or so and then was off for at least that long. This one goes for 10 minutes, then off for ten minutes and so forth. Is the correct? This is a 95% efficiency furnace. The Lennox was an old Pulse 21 that Lennox does not make parts for anymore.

Check out some similar questions!

Runs only on injection fuel poulan xr95 brushcutter [ 2 Answers ]

New fuel, carb kit installed, fuel lines open and flowing, new fuel filter, fuel injector works, acumulator chamber working, new spark plug, good spark, engine runs after pushing fuel injector Then starts to die when that fuel is used up but will keep running if you hit the injector again till...

Poulan weed eater xr95 runs for 5 seconds [ 0 Answers ]

Will run for five seconds with a pump of fuel from the fuel injector then dies. Cleaned out carb and put in a carb rebuild kit and does exactly the same thing. Runs for five seconds then dies. If I pump the injector when it is dying it will run till that fuel is used up then die again. So I know it...

Furnace burners ignite but won't stay lit on my trane xe78 furnace? [ 0 Answers ]

I have a Trane XE78 furnace and the flames come on for about 5-10 seconds and then shut off. They re-ignite about 10 seconds later, then shut off 5-10 seconds after the 2nd ignition. I believe they flame on one more time, shut off and then never re-ignite and the blower just runs and runs with...

Do trane gas Furnace have belt and how to fix trane gas Furnace [ 1 Answers ]

I have trane gas Furnace and its stopped working the pilot is not working its keep shutting off and also the switch on and off is working but the pilot and burner is not working what should I do ?:(

20 yo trane furnace [ 2 Answers ]

I replaced the furnace filter, put the door back on etc and the furnace didn't kick in once I turned up the heat. The furnace worked just fine before? Is there a manual restart somewhere? I followed the directions turing the gas off and the furnace off and then back on etc, but that didn't work. I...

View more questions Search

Check out some similar questions!

Add your answer here.