Ask Experts Questions for FREE Help !
Ask
    Charlie Barry's Avatar
    Charlie Barry Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jan 17, 2013, 04:42 AM
    Empire heaters troubleshooting
    I have an RH65B NAT heater. Gas is getting to the unit, but the ignitor is not working and no gas is going to the pilot.
    endent's Avatar
    endent Posts: 13, Reputation: 2
    New Member
    		  
    #2

    Jan 24, 2013, 11:59 AM
    Have you cleaned the ignition/pilot components?
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Empire heaters troubleshooting [ 1 Answers ]

I have an empire gas wall furnace (60,000 BTU) It will light and the main burner comes on for a second or two then goes out and does this over and over. I replaced the thermostat but nothing changed any sugestions.

Troubleshooting rheem water heaters [ 8 Answers ]

I have a Rheem 50 gallon electric water heater model 81VR52DT. Setup with Therm-o-Disc thermostats double element non-simultaneous operation. Problem is that lately we are running out of hot water. Both top and bottom elements have 20ohms +/- resistance (measured with a Fluke 8060a). The bottom...

Troubleshooting york gas heaters [ 0 Answers ]

Single family Gas whole house heater(York)!When calling for heat it goes through the initial steps!Thermostat calls for heat. The ignighter glows bright orange! The burners light!Then a moment later go out!This sequence repeats itself then the blower motor comes on and then it pushes cold air...

Troubleshooting empire floor furnace [ 1 Answers ]

Replaced generator, pilot light still won't stay lit. empire floor furnace.

View more questions Search