Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Clog in water supply lines after replacing section at main municipal supply...
[ 1 Answers ]
I had an exposed water supply line that ran from the city inlet to my house. It was old and rusty so we decided to replace it with a PEX pvc piping. It's the same dia. (3/4") and we replace the one 90 elbow with a 45 instead. When we turned the water back on, it had no pressure, and after my...
Connecting Copper Supply Lines to Brass Supply Lines
[ 3 Answers ]
I have just started remodeling my kitchen and am looking to move my kitchen sink further down the wall. The kitchen is completely gutted at this point. The supply lines in my house are all brass. I'm looking to stem off the brass lines using copper tubing. Is it possible to cut the brass supply...
Clawfoot tub solution for wall supply lines instead of floor
[ 4 Answers ]
We are finishing our basement and in the bathroom we are putting in a clawfoot tub. My husband put the supply valves in the wall because he was afraid of freezing in the floor. But because of this we cannot find any supply lines that come from the wall they all come from the floor. Is there...
Supply lines
[ 3 Answers ]
Just a question regarding supply lines. I'm pretty sure I'm going with CPVC for the supply side. Planned on making a 3/4" or 1" manifold then branching off that with 3/4" for the main lines with 1/2" for all my fixtures. I have to supply 2 full baths, 1 kitchen and to outside spickets. Can I...
Can I run Supply lines in outside wall
[ 2 Answers ]
I live in NJ and am remodeling a bath. Can I run my supply lines to the shower in an outside wall? If so any recommendations or hints concerning this? View more questions Search
|