Ask Experts Questions for FREE Help !
Ask
    dannevans's Avatar
    dannevans Posts: 1, Reputation: 1
    New Member
     
    #1

    Dec 24, 2012, 09:31 PM
    Coleman evcon furnace troubleshooting
    Indusor motor comes on, then ignitor glows, flames up and then goes out in few seconds. Does this three times, and locks out with ignition failure as code. Replaced flame sensor already. It is one that has centrifical switch instead of pressure switch # DGAT 056 BDD
    Grady White's Avatar
    Grady White Posts: 1,417, Reputation: 59
    Ultra Member
     
    #2

    Dec 25, 2012, 05:37 PM
    Are you sure the flame is hitting the sensor rod?
    Make sure you have a good ground.
    To check the flame sensor you will need a micro ampmeter.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Coleman evcon furnace troubleshooting? [ 5 Answers ]

The regulator clicks and the furnace does not light.

Coleman evcon furnace model no. DGU10014UB troubleshooting [ 11 Answers ]

Coleman furnace referenced in subject line ignites, getting gas, blower starts, runs for a couple minutes, unit shuts down, red LED light on board blinks ten times. Anyone know the code for this repair? I'm FREEZING! :(

Coleman evcon furnace troubleshooting freezing inside coils [ 1 Answers ]

Coleman Evcon model number EB15B will only run on "Emergency" heat mode. Compressor froze over and coils are freezing.

Troubleshooting Coleman Evcon Furnace? [ 1 Answers ]

I have a coleman evcon direct vent forced air furnace (gas with electric ignition). The motor runs, but it does not ignite. The blowers work fine on fan mode but will not ignite or blow on auto. Any suggestions?

Coleman evcon furnace troubleshooting freezing inside coils [ 0 Answers ]

Coleman Evcon model number EB15B will only run on "Emergency" heat mode. Compressor froze over and coils are freezing.


View more questions Search