Ask Experts Questions for FREE Help !
Ask
    BlakJackJoe's Avatar
    BlakJackJoe Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Dec 21, 2012, 03:54 AM
    Dimensions hydroflo vs2 shower
    My Hydroflow Vs2 or is it V52 - anyway the thinks has stopped working properly - cold water not dragging hot through and then when I turn it off the hot water keeps coming - couple of nice scalds for far.

    What I want to do is replace the old unit with a new one but keeping the same pipework layout -

    Any ideas out there on what to do?
    speedball1's Avatar
    speedball1 Posts: 29,301, Reputation: 1939
    Eternal Plumber
    		  
    #2

    Dec 21, 2012, 09:00 AM
    Replace with a Moen or Delta. The supplies should line up. Good luck, Tom
    BlakJackJoe's Avatar
    BlakJackJoe Posts: 2, Reputation: 1
    New Member
    		  
    #3

    Dec 22, 2012, 02:05 AM
    Hi Tom

    Cheers for the advice and sorry to be a pain but are the Moen / Delta shower units?

    I can't seem to find them in any UK catalogue.

    Your help much appreciated

    Regards

    David
    speedball1's Avatar
    speedball1 Posts: 29,301, Reputation: 1939
    Eternal Plumber
    		  
    #4

    Dec 22, 2012, 08:22 AM
    Hey David,
    You're no pest and here's a internatioinal site fir Moen. http://www.moen.ca/region-lang-selector
    Good luck. Tom
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Shower drain traps close dimensions [ 5 Answers ]

The shower drain has a narrow allowance between the height of the shower floor and the hard floor where the plumbing drain pipes are. Is there a smaller drain trap that doesn't have as much of a total height dimension?

An existing bathtub may be replaced by a shower it its overall dimensions are [ 2 Answers ]

If I take out a bathtub how big of shower can I replace it with

Motion in Two dimensions [ 6 Answers ]

A ball is thrown off a 28 m high cliff at 3 m/s, 50 degrees above the horizontal(Xaxis). How long does it take to hit the ground?

Enclosure Dimensions [ 1 Answers ]

I am not sure how to even start this word problem. The word problem is this: The area of the square base is 12 more than its perimeter. Find the length of a side. I am not sure if I need to use the area and perimeter formulas to start this problem or if I just need to use one of the formulas. ...

View more questions Search