Ask Experts Questions for FREE Help !
Ask
    Robinson5's Avatar
    Robinson5 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Dec 20, 2012, 04:53 AM
    How do I fit a kitchen rail
    A hollow tube that fits between two fixing pieces that are attached to a unit- the tube can revolve
    speedball1's Avatar
    speedball1 Posts: 29,301, Reputation: 1939
    Eternal Plumber
    		  
    #2

    Dec 20, 2012, 07:27 AM
    Your post is very confusing. Care to try again? Tom
    joypulv's Avatar
    joypulv Posts: 21,591, Reputation: 2941
    current pert
    		  
    #3

    Dec 20, 2012, 07:40 AM
    You need the end pieces, and have the tube? Go to a hardware store with the tube and get closet pole supports. They are wooden or hard plastic, and you screw them into whatever's on each side, presumably cabinets.

    Just a guess; I too am confused by the question..
    hkstroud's Avatar
    hkstroud Posts: 11,929, Reputation: 899
    Home Improvement & Construction Expert
    		  
    #4

    Dec 21, 2012, 04:08 PM
    Show us a picture.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Way to locate ballister on bottom rail of e-z fit rails [ 1 Answers ]

I am trying to figure out how to locate the balusters on the bottom rail. The top side has mitered holes that they fit in. Instructions say to screw the baluster to the top side on the bottom rail. What is the trick to accurately mount (spacing, center pilot hole)?

How do I take off about 1/4 of an inch off my kitchen kickboards to make them fit? [ 2 Answers ]

After fitting new floor in kitchen my kick boards no longer fit. How do I take off about 1/4 inch, they are standard chipboard. Thanks

Kitchen sink fit new outlet pipes [ 1 Answers ]

Have fitted new kitchen sink and taps OK. Now trying to fit new outlet for sink and dishwasher with parts from B&Q, 40mm fittings. Can't seem to get it sorted,lost my way. Which parts do I need to go fron sink to outflow pipe picking up dishwasher outlet on route,please?

New kitchen faucet hoses do not fit existing water shut off valve. [ 1 Answers ]

I just changed out our kitchen sink faucet. Removal of old and installation of new went well... the problem is the water hook-up. The new faucet fittings are 3/8" compression fittings. The water lines from the new faucet to the water shut off valve are a PVC type. The old faucet had copper tubing...

Uses for old rail ties [ 5 Answers ]

Does anyone know what I could use old used rail ties for? Or even a website that might show ideas on what to use old used ties for? I have quite a lot of them.

View more questions Search