Ask Experts Questions for FREE Help !
Ask
    Ivysgroup's Avatar
    Ivysgroup Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Dec 13, 2012, 04:12 PM
    Heating Thermostat Problems
    Brand-new Comfort-Aire 80% furnace with Pro digital thermostat. Set thermostat at 69 degrees. Furnace goes on, temp goes to 69. Furnace shuts off. Then it gets cold but thermostat shows 68. Then it comes back on. I shouldn't feel cold if it only dropped 1 degree.

    Help!
    riktofte's Avatar
    riktofte Posts: 2, Reputation: 1
    New Member
    		  
    #2

    Dec 13, 2012, 04:28 PM
    Check the settings in the setup procedure.
    Sometimes it's the default setting for another type of system
    And not for your type of system. Let us know how it goes Thanks
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

I have a hot water heating system , the thermostat uses 12/2 wiring what thermostat [ 5 Answers ]

I am looking for a new thermostat for my home heating. I have an oil burner that uses water in baseboards ( I believe hydronic) the current theromstat uses a 12/2 wire that goes to it. This wire has a black, white and nuetral. The current thermostat is very straight forward and these wires...

Heating/ thermostat problems [ 2 Answers ]

I don't know much about HVAC because I haven't had many problems till now. My thermostat (honeywell T8001C) display goes blank and the heat will not turn on. I've tried flipping the breakers in the garage. That won't work. Any ideas?

Furnace heating even though thermostat is off [ 2 Answers ]

I have a burnham gas furnace (baseboard hot water heat) . Three zones each with Taco zone valves/heads. Three sepearate Honeywell thermostats. Problem occurred with only one zone. The upstairs was heating way past what thermostat was set at. Even after turning thermostat down all the way,...

Heating - Thermostat Control [ 3 Answers ]

I have a maple chase Thermostat control in my home. It was flashing low battery, I changed the battery,I had also noticed the temp had dropped to 63,(at all times I keep it set at 68 in the fall in winter months). Since I have changed the battery I cannot get the temp back up above 60. It will...

News Thermostat Heating Problems [ 1 Answers ]

I have installed a new Honeywell thermostat in my apartment. I have a Electo-Hydronic Mark III heating/ac unit made by Snyder General. The problem that I'm having is as follows: When the heat first starts it takes a few minutes, maybe 3-5 for the actual heat pump to kick on. At first its just...

View more questions Search