Ask Experts Questions for FREE Help !
Ask
    zebra123h's Avatar
    zebra123h Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Dec 10, 2012, 09:29 PM
    Ac heaters trouble shooting
    Is the fan suppose to stay on the on position instead of automatic?
    ma0641's Avatar
    ma0641 Posts: 15,675, Reputation: 1012
    Uber Member
    		  
    #2

    Dec 10, 2012, 09:39 PM
    Typically not, but you can. It tends to give you more equal temp distribution but runs up your electric bill.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Trouble-shooting [ 1 Answers ]

I have a 2012 Honda Civic LX 1.8 bought at city auction 'as is' all the front of the car was crashed, all body and visual damaged parts were replaced, car takes off in first gear and as you gained speed goes in neutral, no wiring diaphgram or scan tool available. Thank you

Powervent water heaters PVP50F trouble shooting guide? [ 1 Answers ]

I have a lock out code displayed on my water heater indicating the flammable vapor sensor has responded and locked out the system. I had the same issue last week and the local technician called the manufacturer and got the reset procedure. Does anyone know the reset procedure? I would like to...

Trouble shooting my T.V. [ 1 Answers ]

I have an older model rear projection television, the video and sound both went out at the same time, anyone have an idea on what I need to change out

Trouble shooting [ 1 Answers ]

hi I have 1997 dodge ram 1500 4x4 my tail light went out and then the single light would . Cheeked out both. Bulbs on the right side, know the kicker is the hazzards work, the turnsignal works, if I step on the break.pleas help. Note I have replaced the turnsignal switch. still no luck.

Furnace Trouble shooting [ 1 Answers ]

I have an Coleman Evcon Furnace. Model #15020A the problem is I replaced the Inducer motor, and The furnace starts like normal but then the flames goes out after about a minute or two. The LED light says the Pressure switch is stuck open but it seems fine. I tried to replace the PC board but can't...

View more questions Search