 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Ford windstar stopped pulling while driving.
Was driving got off highway about 2 minutes later just stopped pulling.already dropped pan and changed fluids and filter. Whlie changing, found bolt in pan on magnet. Found where it went and put back.was running fine now just stopped pulling and its been about a week and a half.
|
||||
Check out some similar questions!
1,2,D don't work but the upper gears seemed to work, once I got up to speed. Any suggestions?
My 1991 Ford f-150 inline stright 6 4.9L engine stopped while driving(moving at 35 mph) I replaced both fuel tanks, fuel pumps, new fuel filter , and new fuel line from the filter on back to the rear tank. New distributor cap, rotor, wires, spark plugs, coil, and TFI(on side of distributor). New...
How large of a task is it to replace Tie-rod ends(?) and lower ball joints? Are there any sites I can visit to get more information?
Hello Everyone:) I was on my way too the grocery store, when the my windstar van suddenly died? No hints to help me diagnose. No codes from my OMD II (is this right?) that my dad had bought for my birthday. It won't go into R, D, 1,2, despite starting and reving with no problems. I wish I could...
I have a 99 Ford Windstar that is intermitently starting and not starting. I have had the starter and cylenoid checked, no issue. I have recently on Monday replaced the positive connector on the battery and it started after being jumped (which before it did not do) so I let it run to charge the...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
