Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Metal Roof Construction
[ 8 Answers ]
A contractor is putting on a metal roof for me but I have an issue I hope someone can answer I have a hip roof(4sided roof that meets as a common peak)... The metal where the roofs meet at each of the four corners have gaps running from the bottom of my roof to the top.. They say the ridge...
Deck roof construction calculations
[ 5 Answers ]
I'd like to put a roof over my deck. Its easy to find tables to calculate timber for decks, but not for roofs. Is the load calculation the same for a roof/deck cover as a deck (e.g. 10 lb/sf dead load, 40 lb/sf live load)? Does one treat the live load of a roof (snow) the same as live load for a...
Shed Roof Construction
[ 12 Answers ]
I am in the planning phases on an addition and have some questions about the roof. It is approximately 5'x' in size and is a shed roof. It will abut an existing brick wall both on two sides, along the back and along one of the sides. The architect is calling for a 2/12 slope. I have a couple of...
Metal roof construction
[ 4 Answers ]
I'm fixing to construct a metal roof to replace my asphalt shingle roof. I have 2 main questions: 1. Do I need to remove the old shingles? There is only 1 layer & most metal roofs I'm aware of simply left them in place. 2. I've been approached about a solar insulation to be placed under...
Construction of roof trusses
[ 1 Answers ]
The trusses are 12 5 pitch I want to cut into them a foot It's a metal pole barn, its 12 foot high I want to make it 13 foot high Is this feasible? Thank you John View more questions Search
|