 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Rheem furnace rapid flashing light
My furnace started acting weird about a week ago. The igniter sometimes works but after it hears to an adequate temp the blower keeps going blowing cold air in the house. Other times it will not even ignite but the blower comes on with the cold air again. The left light is flashing rapidly orange. I have replaced three heat sensors, the igniter and the vacuum valve piece that prevents the heater from working if there is a blocked exhaust at the advice of a friend. Still doesn't work and tonight it quit igniting altogether. We have also replaced the thermostat with no luck.
|
||||
Check out some similar questions!
gibson furnace.. turned thermostat on, no ignitor, no flame, but blower comes on red light blinks twice== pressure switch with inducer on Any way to fix this without buying new part ?
Hello, I just bought a new control board for my carrier furnace and did the replacement but now I have an error, so my question is would you reverse line polarity first or control leads ? I am afraid of ruining the board if I do the wrong one first, but I have read a lot of questions and most of...
My gas furnace is blinking red and continious, and on the back of the door its says that this means "internal control failture" so I need to know what that means. Is it one problem or a number of things I need to check? Help!
My Rheem furnace is showing a diagnostic red flashing light, flashing 3 times m/n# A0336JK06X PC boerd 62-23599-01
I have a Ruud Silhouette II Gas Furnace. The whole unit is turned off/on by a light like switch. The AC is working, but the heater is not. It appears that no gas is flowing to the burner. The PWR light is on, steady. The OK light is flashing; three times on, then off. The Flame light is off in...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
