Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Ask a mechanical engineer
[ 0 Answers ]
I have five small DC motors with gears on them already I want to design one big gear for four of them, but when I bought these motors they came with no specs with them, I tried contacting the manufactuer but they could not help. Is there a way to calucate the size of the pinion gears without any...
Ask a mechanical engineer
[ 19 Answers ]
If I have two equal coil springs, and I compress the first one two inches, can that stored energy be used to compress the second spring two inches ? In other words can the first one relax and compress the second an equal distance ?
Questions to ask a mechanical engineer?
[ 1 Answers ]
We have an aluminum window sill with a .1" width X .3125 depth. The outside edge of the groove has a .025 continuous barb. We are installing a .050 aluminum formed sill into the groove. The edge of the sill that goes into the groove has a lanced barb every 6", 050" deep and 3/16" inside the edge....
Insi of mechanical engineer(india) oreng ime is equvelnt to B Tech mechanical
[ 0 Answers ]
Insi of mechanical engineer(india) ime is equvelnt to Regular B Tech mechanical engineering? After ime we can take addmision in M Tech in regular? Its very hard to clear all subject?
Ask a mechanical engineer
[ 0 Answers ]
I have a hobby of making coin rings by tapping a silver coin around its circumference edge with a small hammer while I turn the coin on top of an anvil to flatten the edge until it reaches a desired width and diameter. Then I cut the center out and polish it. I need advice or an idea to make this... View more questions Search
|