Ask Experts Questions for FREE Help !
Ask
    headsavers's Avatar
    headsavers Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Nov 10, 2012, 09:03 PM
    Fan on furnace won
    When the thermostat calls for heat, the igniter will ignite the gas pilot. After awhile, the burner will turn on. After one minute instead of the blower fan turning on, the burner shuts off. What could be the problem?

Check out some similar questions!

Carrier furnace: limit switch fault furnace has ignition but blower will not come on? [ 2 Answers ]

Board says it is a limit switch fault Furace goes into pre ignition, fan comes on and sometimes even the main burner ignites, but the blower will not come on... is this the blower motor or could this be a switch somewhere?

Intertherm furnace codes? This furnace flashes the yellow light 6 times [ 0 Answers ]

Furnace will run for 30 seconds. It shuts down and the yellow light will flash 6 times and the does the same thing over and over. Red light stays steady. Thanks for the help.

Goodman furnace GMNT080-4 furnace runs good for a while then has to be manually reset [ 5 Answers ]

I have a Goodman GMNT080-4 (90%). I'm having the same problem As Streatherg did back in the Nov 2006 question. I reviewed his article and tried Every thing on there but seems to be doing the same thing. The furnace kicks on for about an hour then locks out and has to be manually reset threw...

Intertherm furnace e2eb-017hb runs briefly, shuts off, then furnace just clicks [ 3 Answers ]

I have an Intertherm furnace, e2eb-017hb. It comes on briefly, blows warm air, then shuts off, and a clicking sound comes from the coil contacts area. I have tested the t-stat, and also replaced a coil contact, thinking that was the problem. I would appreciate any help on what to do next.

Furnace not heating the house. Damper on the furnace not opening. Motor then shuts. [ 4 Answers ]

My forced-air furnace is not working correctly. The gas works heating the air in the furnace, but When the motor starts the damper doesn't open and the Motor shut down. I need suggestions?:mad:

View more questions Search
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.