 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Can I add the humidifier wires to honeywell rth7600
OK I have an old house 1975 with the mercury switch thermostat and a humidifer adjustment next to it. When I pull each unit away from the wall they both have only 2 wires attached to them.
Thermostat: Black & White wire Humidifier: Black & White wire I purchased a Honeywell RTH7600 7-day programmer. Question is: Where do I wire the Thermostat wires to? And can I wire the humidifer wires into also? Or have to keep it separate. |
||||
Check out some similar questions!
Recently purchased and installed today. Referred to manual for clock settings. Followed directions and did the following. Pressed clock and other, set time and pressed done. Cannot determine how to move to the month day, etc. The instructions in the manual do not go beyond setting time other...
Why does the thermostat run for 1 minute every 10 minutes on the heat cycle?
Looking for the wiring match-up to replace my existing thermostat 51H4301 to a Honeywell RTH7600 unit. My outside unit HP21-511-4P and the inside unit is CB19-51-3P-TXV. The current wiring for the thermostat is: O G C R T W1 - two tied together on one screw Y1
I currently have a Honeywell T841A1217 and want to install an RTH7600. The wiring labels are different. T841A1217 has W2,X,O,E,G,Y,R. The RTH7600 has C,G,Y,O/B,RC,R,AUX,E,L. The RTH7600 also has C,G,Y,W,RC,R,W2,Y2. I have a 2.5 ton Carrier Heat Pump.
I have a honeywell RTH7600 thermostat. The inside temperature on the termostat says it is 4 degrees higher than the room actually is. It says it is 78 degrees and it is actually 74 degrees. Is there a way to calibrate the thermostat to show the true temperature?
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
