Check out some similar questions!
Need schematic for carrier rooftop 48HD008. Does unit have a pilot sensor?
[ 1 Answers ]
Has a G67BG-3 control with the sense wire hanging loose. Cannot see a pilot flame sensor. Unit worked until one week ago. Where is the pilot flame sensor located?
The gas comes on intermittently on my rheem rooftop combination unit
[ 0 Answers ]
The small blower comes on and the air-flow switch closes always but the gas and igniters only come on sometimes. I have checked connections and cleaned contacts, etc. I used an ohmmeter to verify that the air switch closes when the small blower comes on. The thermostat is trying to increase the...
Bryant Rooftop hvac unit not cycling properly
[ 1 Answers ]
I Have an older Bryant 6-ton rooftop unit model 580c that will run for a few minutes... shut off but will NOT "cycle" back on for heat. You would have to "re-set" by powering off/on at the breaker panel. I am getting a "CODE #6 Inducer Motor Fault" even though motor seems to be functioning OK. It...
Heil Rooftop Unit condensate pan craceked
[ 2 Answers ]
Im a store owner and I have a 5 ton HEIL rooftop unit. The condensate drain pan is cracked where the pvc fitting goes into pan. Water is dripping into my store. I want to replace pan myself. What are some of the basic step's I need to take to replace entire pan. Is there a tech. number I can...
Wiring new 712-008 pilotless ignition to old Rheem rooftop unit
[ 1 Answers ]
Help; I have installed a Uni-Line 721-008 pilotless system in my 1979 Rheem RRAB-08E48JR rooftop HVAC unit. I have 3 original wires to hook to the new unit that has 2 wires (black and gray) remaining to be wired. 1 original old black wire comes from the transformer into the heater... View more questions Search
Add your answer here.
|